ノック解析(1) CARSによるエンジン筒内未燃ガス温度の高精度測定と自着火反応モデルの評価

Size: px

Start display at page:

Download "ノック解析(1) CARSによるエンジン筒内未燃ガス温度の高精度測定と自着火反応モデルの評価"

おさむあざみ
7 years ago
Views:

1 15 Analysis of Knock Phenomena (1) Unburned Gas Temperature Measurement by Accurate CARS Thermometry and Validation of a Reduced Chemical Kinetic Model for Auto-ignition Kazuhiro Akihama, Michio Nakano, Shuichi Kubo CARS 100K 20K 150K 40K CARS Cowart 2.5deg. Accurate CARS thermometry was developed in order to measure the unburned gas temperature in an engine. CARS system was modified by using singlelongitudinal-mode pump beam, by eliminating nonresonant components with polarization technique and by improving the spectral resolution of the detection system. This modification greatly improved the accuracy of temperature measurement of the averaged and single-shot CARS from 100K to 20K, from 150K to 40K, respectively. Unburned gas temperature in a single-cylinder engine was measured by accurate CARS thermometry. As a result, it was experimentally proved that the unburned core gas was compressed adiabatically. The temperature difference between the knock and non-knock cycles, and the heat release due to end-gas reactions were measured exactly. The reduced chemical kinetic model for auto-ignition, developed by Cowart et al., was investigated in terms of not only knock onsets but also the unburned gas temperature. The adjustment of the isomerization reaction in their model was required to give agreement between the predicted and observed knock onsets and temperature. However, the model calibrated in this study was not able to represent a steep temperature rise at auto-ignition. Knock onsets on a cycle-by-cycle basis was predicted within the accuracy of 2.5 deg. crank angle using the calibrated model. Finally, the effects of non-uniformity of the unburned gas temperature and the mixture for knock occurrence were discussed. CARS R&D Vol. 31 No. 2 ( )

CARS system was modified by using singlelongitudinal-mode pump beam, by eliminating nonresonant components with polarization technique and by improving the spectral resolution of the detection system.

2 16 ( ) ( ) 1000K 1 CARS ( Coherent Anti- Stokes Raman Spectroscopy ) ( 10 5 ) CARS 1000K CARS CARSCARS ( ) CARS Nd:YAG 2 ( 532nm ) 532nm 2330cm 1 607nm 100cm CARS ( ) CARS CARS Schematic diagram of CARS set-up. R&D Vol. 31 No. 2 ( )

Nd:YAG 2 ( 532nm ) 532nm 2330cm 1 607nm 100cm 1 640 1 CARS (

3 17 ( ) CARS Fig. 1 CARS CARS Fig. 1 YAG ( 0.003cm 1 ) YAG YAG 50% CARS YAG 15% CARS ( ) ( ) CARS Fig. 1 1/ K CARS Fig. 1 ( 3.6 Fig. 1 dispersion magnifier ) cm K K 4 5K CARS (a) (b) CARS CARS (a) Fig. 1 [ (b)] ( Q ) 300 ( CARS R&D Vol. 31 No. 2 ( )

1 1/1000 1000K CARS Fig. 1 ( 3.6 Fig. 1 dispersion magnifier ) 4 0.

4 18 ) 20K 20K CARS 20K 600K σ 2σ 40K Average CARS spectra (300 laser shots). Measured CARS spectra of N2 Q-branch. (a) Spectra before improvements of CARS system. (b) Spectra after improvements of CARS system (Fig. 1). Temperature error for various temperatures and pressures. Histogram of measured temperature by singleshot CARS. R&D Vol. 31 No. 2 ( )

(b) Spectra after improvements of CARS system (Fig. 1).

5 19 CARS ( TRE-II ) 4 CARS ( 5kHz ) 0.025MPa 50% 25deg.BTDC ( Before Top Dead Center : ) The accuracy of temperature measurement of averaged and single-shot CARS in the temperature range of K for pressures of MPa. Accuracy Method Before After improvements improvements (Fig. 1) Average (300 shots) ±100K ±20K Single-shot ±150K ±40K Single-shot CARS spectra. TRE-II engine specifications. Type Single cylinder, SOHC 2valve, Oil-less Chamber Pancake type Fuel delivery Port injection Bore 83.0 mm Stroke 85.0 mm Compression ratio 9.2 Schematic of the measurement geometry and location of the CARS measurement point. Operating conditions. Speed 1200 rpm Fuel PRF RON100 (isooctane) Equivalence ratio 1.0 Intake air temperature 33 C Ignition timing 25 deg BTDC Throttle lever Wide open throttle R&D Vol. 31 No. 2 ( )

Accuracy Method Before After improvements improvements (Fig. 1) Average (300 shots) ±100K ±20K Single-shot ±150K ±40K Single-shot CARS spectra. TRE-II engine specifications.

6 20 50%Fig. 1 YAG 300 CARS Fig CARS ( 25deg.BTDC 1.1MPa ) CARS Fig. 8(a) 650K ( Fig. 6 ) ( 1% ) [Fig. 8(b)] K 48K Fig. 8(b) 650K 10 CARS300 Table 120K 30K 200 7deg.ATDC ( After Top Dead Center : ) ( ) ( 50% ) ( ) ( ) ( ) CARS spectra at 25 deg.btdc. (a) Single-shot. (b) 300 shots average. Histogram of temperature at 25 deg.btdc measured by single-shot CARS. R&D Vol. 31 No. 2 ( )

ATDC ( After Top Dead Center : ) ( ) ( 50% ) ( ) ( ) ( ) CARS spectra at 25 deg.btdc.

7 21 7deg.ATDC 60K ( 100K ) CARS 5mm 4mm 4mm ( Fig. 7 ) Lyford- Pike Heywood 2mm ( Fig. 10 ) Mean pressure and temperature histories for knocking and non-knocking cycles. γ 1 T = T 0 P γ P 0 T : : γ : (1) T 0 P 0 CARS ( 639K, 1.1MPa ) Fig. 10(1) TDC ( ) TDC (1) Fig. 10 Fig. 9 ( Fig. 5 ) CARS 1% Fig. 9 (1) (2) ( ) (3) TDC R&D Vol. 31 No. 2 ( )

γ 1 T = T 0 P γ P 0 T : : γ : (1) T 0 P 0 CARS ( 639K, 1.1MPa ) Fig.

8 22 Cowart ( two-stage ignition ) ( hot flame ) ( cool flame ) Table 4 RH Reduced γ γ 1 γ : T : P : q : R : (2) (2) 25deg.BTDC CARS ( 639K ) 5.5vol% (2) 1200K 16deg.ATDC (a) Cowart alkylperoxy foward ( Table 43, E 3 = 21.2 kcal )Fig. 12(a) (b) E 3 1 dt T dt = 1 dp P dt + 1 dq RT dt Cowart Fig. 12 ( Table 4 ) R&D Vol. 31 No. 2 ( )

5vol% (2) 1200K 16deg.ATDC (a) Cowart alkylperoxy foward ( Table 43, E 3 = 21.

9 23 Fig. 12 ( 1100K K/sec ) Reduced chemical kinetic model. (a) 17 species RH (fuel), O 2 (oxygen), R (alkyl fuel radical), HO 2 (hydro peroxy radical), RO 2 (alkylperoxy radical), ROOH (hydro peroxy alkyl radical), O 2 RO 2 H, OROOH (hydro perozide), OH (hydroxyl radial), H 2 O (water), ORO, C=C (olefin), HOOH (hydrogen peroxide), R'CHO (aldehyde) R''O, R'CO (acyl radical), Epox (epoxide). (b) 19 reactions Arrhenius parameters of equilibrium constants K = A exp( E/RT) and rate constants k ± = A ± exp( E ± /RT) are for isooctane oxidation at 700 < T < 1300 K. (Units : cc, mole, sec, kcal) (*) Cowart et al. (**) This work Reaction H 300 Log A E Log A + E + Log A E 1 RH + O 2 R + HO R + O 2 RO RO 2 ROOH (*) (**) 4 ROOH O 2 RO 2 H O 2 RO 2 H OROOH + OH RH + OH R + H 2 O OROOH OH + ORO R + O 2 HO 2 + C=C HO 2 + HO 2 HOOH + O HOOH + M 2OH + M ORO R'CHO + R"O RO 2 + HO 2 ROOH + O ROOH OH + R'CHO + C=C RO 2 + R'CHO ROOH + R'CO HO 2 + R'CHO HOOH + R'CO C=C + HO 2 Epox + OH HO 2 + RH R + HOOH RO 2 + RH R + ROOH R + R RH R&D Vol. 31 No. 2 ( )

(hydroxyl radial), H 2 O (water), ORO, C=C (olefin), HOOH (hydrogen peroxide), R'CHO (aldehyde) R''O, R'CO (acyl radical), Epox (epoxide).

10 24 Individual-cycle knock occurrence crank angle distribution. 5.3 ( E kcal ) (2)P deg. Fig. 13 Comparison between the measured temperature by CARS and the calculated temperature by reduced model listed in Table 4. (a) Knocking cycle. (b) Non-knocking cycle. Measured versus predicted knock occurrence crank angles. R&D Vol. 31 No. 2 ( )

13 Comparison between the measured temperature by CARS and the calculated temperature by

11 25 Fig. 13 ( 2.5deg. ) ( ) ( ) 1% 0.7deg. 1.8deg. 1.8deg. CARS (1) CARS 100K20K 150K40K (2) CARS (3) 2.5deg. (4) (2) 4 1) Cowart, J. S., et al. : Twenty-Third Symposium (International) on Combustion, (1990), ) Westbrook, C. K. and Pitz, W. J. : Lawrence Livermore National Laboratory report UCRL-JC , (1993) 3) Cox, R. A. and Cole, J. A. : Combustion and Flame, 60 (1985), 109 4) Lucht, R. P., et al. : Combustion Science and Technology, 55(1987), 41 5), 2 : 9, (1991), 63 6), 2 : (B ), (1993), ) Akihama, K. and Asai, T. : Appl. Opt., 29-21(1990), ), : (B ), (1990), 200 9) Akihama, K., and Asai, T. : JSME Int. J., Ser. B, 36-2(1993), ), 5 : 10 (1992), ) Lyford-Pike, E. J. and Heywood, J. B. : Int. J. Heat and Mass Transfer, 27-10(1984), ) Dimpelfeld, P. M. and Foster, D. E. : SAE Tech. Pap. Ser., No , (1986) 13) Hu, H. and Keck, J. : SAE Tech. Pap. Ser., No , (1987) 14), 2 : 10 (1992), 289 R&D Vol. 31 No. 2 ( )

and Cole, J. A. : Combustion and Flame, 60 (1985), 109 4) Lucht, R. P., et al. : Combustion Science and Technology, 55(1987), 41 5), 2 : 9, (1991), 63 6), 2 : (B ), 59-566(1993), 3249 7) Akihama, K.

12 26 15) Bäuerle, B., et al. : Twenty-Fifth Symposium (International) on Combustion, (1994), ), 3 : R&D, 31-2 (1996), CARS, LIF R&D Vol. 31 No. 2 ( )

Combustion, (1994), 135 16), 3 : R&D, 31-2

レーザ誘起蛍光法( LIF法) によるピストンの油膜挙動の解析

レーザ誘起蛍光法( LIF法) によるピストンの油膜挙動の解析 Analysis of Piston Oil Film Behavior by Using Laser Induced Fluorescence Method Shuzou Sanda, Akinori Saito ( Laser Induced Fluorescence Method LIF ) LIF Scanning -LIF Abstract Analysis of the oil film